The IP-292 detector is clamped around the primary cable and detects primary ignition pulses.
Used to detect the number of ignition pulses produced in gasoline engines. The compact, lightweight and clip-on design make it quick and easy to to capture engine rpm. This detector and cord is made of heat resistance materials and can with stand high temperature.
- For 2 and 4 cycle gasoline engines.
- For measurement on secondary ( high voltage ) cords use the IP-296.
- Operating temperature -40° to 248° F / -40° to 120° C
- Signal cable 4.9 meters long with BNC connector
Old Tachometer Sensor Compatibility Chart
TACHOMETER SENSOR |
TACHOMETER |
||||||
| CT-6520 |
SE-1520 |
SE-1400 |
FT-1500 |
TM-2100 |
GE-1100 |
||
| CP-044 | Clamp-On Fuel Injection Line | Note 1 | X | ||||
| CP-1060 | Clamp-On Fuel Injection Line | Note 1 | X | ||||
| CP-1064 | Clamp-On Fuel Injection Line | Note 1 | X | ||||
| FT-0501 | Magnetic Flux Leakage Detector | X | |||||
| IP-292 | Inductive Clamp-On (Primary) | X | X | Note 2 | |||
| IP-296 | Inductive Clamp-On (Secondary) | X | Note 2 | ||||
| IP-2800 | Inductive Suction Cup (Primary) | X | |||||
| IP-3000 | Inductive Clamp-On (Primary) | X | X | Note 2 | |||
| LG-916 | Optical Tachometer Sensor | MX-800 Series | MX-700 Series | ||||
| MP-910 | Magnetic Pickup | MX-000Series | MX-500 Series | ||||
| MP-981 | Hall-Effect Magnetic Pickup | MX-800 Series | MX-700 Series | ||||
| MP-910 | Magnetic Pickup | MX-000Series | MX-500 Series | ||||
| OM-200 | Magnetic Flux Detector | MX-000 Series | Note 3 | Note 2 | |||
| VP-201 | Vibration Sensing Tach Sensor | X | Note 3 | X | |||
| VP-202 | Vibration Sensing Tach Sensor | X | |||||
| Measurement Microphone | Note 4 | ||||||
| Vibration Transducer | Note 4 | ||||||
KEY
Blank => sensor is not compatible with tachometer Model # => sensor is compatible with tachometer using the specified cable model #
X => sensor is compatible with tachometer using integral cable
Note => sensor may be used with this tachometer with certain restrictions (see below)
Note 1: CP-Series Clamp-On sensors may be used with FT-1500 tachometer for diesel engine rpm measurements. In-line charge amplifier is required. Please contact us for details.
Note 2: IP-Series Inductive sensors may be used with the FT-1500 tachometer for rpm measurements on DC motors. Please contact us to discuss your application.
Note 3: A special modification is available for the SE-1520 tachometer that will permit the VP-201 or OM-200 sensors to be used with the SE-1520. Please contact us for details.
Note 4: The FT-1500 tachometer is capable of measuring the rpm of rotating equipment using sound or vibration sensors (e.g. it is possible to measure engine rpm from sound radiated by muffler). Please contact us if you would like to discuss your application.
